This cute little fellow is all bundled up for those arctic winter mornings at the North Pole!
You will need
- burnt out light bulb
- rubbing alcohol
- acrylic paint in white and black
- gold cord or ribbon
- orange toothpick
- shiny gold ribbon
- gold chenille twist tie
- finger from a child's glove
- white iridescent pom pom
- Fiberfil cotton batting
- hot glue
- black marker
Wipe bulb down with rubbing alcohol, this will help the paint adhere to the bulb. Let dry. Paint entire light bulb with black acrylic paint except for an hour glass shape in the front. When the black paint is completely dry, paint the hour glass shape white and let dry. Apply a second coat. If finish appears streaked, you can use a large paint brush or a sponge to blot on a "stucco" look. It is not necessary to paint the socket. Allow bulb to dry completely.
While bulb is drying, prepare hat and mittens but cutting off a finger from a child's glove. Use the longest finger on the glove, cut a small section for the mittens. The mittens are simply small triangular shapes. To make the hat, put a small amount of Fiberfil into the glove finger and roll up end for a brim. Glue pom pom to the top. You can bend the hat to one side by bending it down and gluing in place.
Fashion a bow tie from 1/2" or 3/4" wide shiny gold ribbon (about 3"-4" in length). To do this, lay the ribbon, shiny side down, onto your work surface. Fold both ends into the center, doubling up the ribbon. If this gives you the length that you want for your bowtie, then glue those ends down to hold in place. Take a piece of shiny chenille twist tie and manipulate it around the center of the ribbon, scrunching the ribbon together, thus creating your bowtie. Hint: these ribbons and twist ties are found on many premade ornaments, some with angels others with flowers.
When bulb is completely dry, pull hat over socket and glue in place. Glue bowtie in the front at the neckline and glue mittens at the edge of the white where the hourglass shape widens. Using black marker, dot eyes onto face and five tuxedo buttons down the front of the bulb. Carefully cut 1/4 of the toothpick off at the pointed end, glue in place for beak.
With a fairly generous amount of hot glue, fasten a loop fashioned from gold ribbon or cord to the back of the bulb. Hang!
Amanda Formaro is the entrepreneurial mother of four children. She and her husband live in southeastern Wisconsin. She is also the owner of FamilyCorner.com Magazine. Subscribe to her free holiday newsletter,Family Holidays, by sending any email message to email@example.com
or by filling out the form on the left side of this article.